67938A
1.REMOVE BACK DOOR SIDE GARNISH LH
Disengage the pins (2) and claw (3).
Disengage the guides to remove the back door side garnish LH (1).
67937B
2.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure as for the LH side.
3.REMOVE REAR BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
Remove the T20 screws (1) on the rear bumper assembly (2).
Remove the screws (1).
Perform the operations on the left and right side.
Remove the screw (1) on the rear bumper assembly (2).
Perform the operations on the left and right side.
Remove the screws (1) on the rear bumper assembly (2).
Disengage the claws (2) on the rear bumper assembly (1).
Perform the operations on the left and right side.
Disengage the claws (2) on the rear bumper assembly (1).
Perform the operations on the left and right side.
Using a moulding remover E, disengage the claws (2).
Disengage the claws (3).
Disconnect the rear bumper assembly (1).
Disconnect the connector (1).
Disconnect the connectors (1).
Disconnect the connector (1).
Disconnect the connector (1).
Disengage the clamp (3) to disconnect the wiring harness (2).
Remove rear bumper assembly.