Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387965 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR BUMPER ASSEMBLY

a.
E414400

Connect the connector (1).


b.

Engage the wiring harness (2) with the clamp (3).


c.
B537172

Connect the connector (1).


d.
B537171

Connect the connectors (1).


e.
E414437

Connect the connector (1).


f.
B542643

Install the rear bumper assembly (1) and engage the claws (2) and claws (3).


g.
B537169

Engage the rear bumper assembly (1) into the claws (2) at side.

HINT:

Perform the operations on the left and right side.



h.
B537168

Engage the rear bumper assembly (1) into the claws (2) at side.

HINT:

Perform the operations on the left and right side.



i.
B537167

Install the screws (1) on the rear bumper assembly (2).

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


j.
B537166

Install the screw (1) on the rear bumper assembly (2).

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)

HINT:

Perform the operations on the left and right side.



k.
B546541

Install the screws (1).

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)

HINT:

Perform the operations on the left and right side.



l.
B537165

Install the T20 screws (1) on the rear bumper assembly (2).

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


m.

Remove the protective tape.


Hide 67938A 2.INSTALL BACK DOOR SIDE GARNISH LH

a.
B537164

Engage the guides (4) to install the back door side garnish LH (1).


b.

Engage the pins (2) and claw (3).


Hide 67937B 3.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.