Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
75852
1.REMOVE ROCKER PANEL MOULDING
Remove the clips (1).
Using a moulding remover A, disengage the claws (2) to remove the rocker panel moulding (1).
75621B
2.REMOVE NO. 1 SIDE PANEL MOULDING
Disengage the clips (2) to disconnect the front door inner trim cover (1).
Remove the screws (1).
| *a | Double-sided Tape |
Disengage the claws and separate the double-sided tape to remove the No. 1 side panel moulding (1).