Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
75697
1.REMOVE NO. 2 BODY OUTSIDE MOULDING PAD
Disconnect the floor wire (2) from holders (1).
Remove the clips (1) and No. 2 body outside moulding pad (2).
2.REMOVE ELECTRICAL KEY ANTENNA
75699
3.REMOVE NO. 4 BODY OUTSIDE MOULDING PAD
Disengage the clamp (1).
Disconnect the floor wire (2) from holders (3).
| *a | Double-sided Tape |
Remove the clips (1).
Separate the double-sided tape to remove the No. 4 body outside moulding pad (2).