Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387968 ROCKER PANEL MOULDING A

EXTERIOR PANELS / TRIM  ROCKER PANEL MOULDING  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75699 1.INSTALL NO. 4 BODY OUTSIDE MOULDING PAD

a.

Clean the surface of the No. 4 body outside moulding pad.

i.

Remove any remaining double-sided tape from the No. 4 body outside moulding pad.


ii.

Wipe off any adhesive residue with cleaner.

Cleaner:

Cleaner R2




b.
B612681C02
2.74,1.24 3.052,1.438 0.313,0.198 10 false *a
*a 150 mm (5.91 in.)


Install a new 150 mm (5.91 in.) double-sided tape as shown in the illustration.


c.
B612679

Install a new 90 mm (3.54 in.) double-sided tape as shown in the illustration.


d.

Remove the release paper from the 90 mm (3.54 in.) double-sided tape.

NOTICE:

After removing the release paper, keep the exposed adhesive free from foreign matter.



e.
B612682

Install a new 20 mm (0.787 in.) double-sided tape as shown in the illustration.


f.

Remove the release paper from the 20 mm (0.787 in.) double-sided tape.

NOTICE:

After removing the release paper, keep the exposed adhesive free from foreign matter.



g.
B612678C02
2.354,0.333 2.094,0.604 true 2.385,0.24 2.698,0.438 0.313,0.198 10 false *a
*a Double-sided Tape


Install the No. 4 body outside moulding pad (2) with the clips (1).

NOTICE:

Press the No. 4 body outside moulding pad to install it.



h.
B537156

Connect the wiring harness (2) to the holders (3).


i.

Engage the clamp (1).


Hide 75697 3.INSTALL NO. 2 BODY OUTSIDE MOULDING PAD

a.
B537161

Install the No. 2 body outside moulding pad (2) with the clips (1).


b.
B537160

Connect the wiring harness (2) to the holders (1).