Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387968 ROCKER PANEL MOULDING A

EXTERIOR PANELS / TRIM  ROCKER PANEL MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75621B 1.INSTALL NO. 1 SIDE PANEL MOULDING

a.

Clean the surface of the No. 1 side panel moulding.

i.

Remove any remaining double-sided tape from the No. 1 side panel moulding.


ii.

Wipe off any adhesive residue with cleaner.

Cleaner:

Cleaner R2




b.

Remove the release paper from the 150 mm (5.91 in.) double-sided tape.

NOTICE:

After removing the release paper, keep the exposed adhesive free from foreign matter.



c.
B537152

Install the No. 1 side panel moulding (1) under the front side panel (2) in the direction of the arrow.


d.
B612677C02
2.417,0.656 2.698,0.51 false 2.74,0.427 3.052,0.625 0.313,0.198 10 false *a
*a Double-sided Tape


Engage the No. 1 side panel moulding (1) and the claws.

NOTICE:

Press the No. 1 side panel moulding to install it.



e.
B537149

Install the screws (1).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


f.
B542642

Engage the clips (2) to connect the front door inner trim cover (1).


Hide 75852 2.INSTALL ROCKER PANEL MOULDING

a.
B537154

Engage the claws (2) to install the rocker panel moulding (1).


b.
B537147

Install the clips (1).