Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387971 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75552 1.REMOVE ROOF DRIP SIDE FINISH MOULDING

a.
B537143

Disengage the clip (1) to disconnect the back door seal (2).


b.
B537144C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape as shown in the illustration.


c.

Using a moulding remover A, disengage the claws to remove the roof drip side finish moulding (1).

NOTICE:
·

Tools and sharp-edged components can cause scratches.

-

Protect working area.

-

Handle tools and components carefully.





d.
B537145

Remove the No. 1 roof drip side finish moulding clip (1).