Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387971 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 75552 1.INSTALL ROOF DRIP SIDE FINISH MOULDING

a.
B537145

Install the No. 1 roof drip side finish moulding clip.


b.
B537146

Install the roof drip side finish moulding (2) in such a way that it makes contact with windshield outside moulding (1).


c.

Install the roof drip side finish moulding (2) in such a way that it lies flush against edge (3).


d.

Install the roof drip side finish moulding fully into roof frame (2).


e.

Remove the protective tape.


f.
B537143

Engage the clip (1) to connect the back door seal (2).