Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER
RM3650E _56 Audio / Visual / Telematics _079983 AUDIO / VIDEO _0387974 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.INSTALL RADIO RECEIVER ASSEMBLY

NOTICE:
·

Damage to the head unit.

The hard disk of the head unit can be damaged by vibration.

-

Carry out mechanical work on the head unit and adjacent components with care.



·

Sensitive optical fibers.

Damaged optical fibers can result in operating failure of the LED.

-

Do not bend optical fibers too much and do not kink, as well. The minimum permissible bending radius is 25 mm.

-

Avoid pressure and tensile loads and heat influences on the optical fiber.




a.

Install the plug.


b.
E415636

Position the radio receiver assembly (2).


c.

Connect connector (1) and lock.


d.
E415635

Connect connectors (1) and lock.


e.
E415634

Attach the guides (2) to install the radio receiver assembly (3).


f.

Tighten the T20 screws (1).

Torque:
2.3 N*m (23 kgf*cm, 20 in.*lbf)


Hide 55011A 2.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 3. ENCODE/PROGRAM CONTROL UNIT(S)

NOTICE:
·

Use the most recent software version to prevent faults during programming/encoding.

·

The battery voltage must not drop below 13.0 V during programming.

·

Use only recommended chargers for a low-voltage vehicle electrical system.

·

Do not exceed the maximum charging voltage of 14.8 V when charging the battery.

·

When there is communication abnormality in the middle of work, control unit might be damaged.

·

It may be necessary to perform the Action Plan several times.



a.

Connect the battery charger to the vehicle.


b.

Connect the diagnosis system with the vehicle.


c.

Determine the action plan.

Service plan / Programming plan / Action plan / Calculate action plan


d.

Accept and fully process the measures plan.

Service plan / Programming plan / Action plan / Perform action plan


e.

Wait until programming/encoding has been completed.

NOTICE:

When there is communication abnormality in the middle of work, control unit might be damaged.



f.

Carry out vehicle test.

Vehicle management / Troubleshooting / Fault memory / Calculate test plan


g.

Delete the fault memory.

Vehicle management / Troubleshooting / Fault memory / Delete fault memory


h.

Disconnect the diagnosis system from the vehicle.


i.

Disconnect the battery charger from the vehicle.