Home › Engine / Hybrid System › B58 (INTAKE / EXHAUST) › EXHAUST PIPE
RM3650E _51 Engine / Hybrid System _080024 B58 INTAKE / EXHAUST _0388139 EXHAUST PIPE A

B58 INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


PROCEDURE

Hide 57628E 1.REMOVE REAR FLOOR SIDE MEMBER COVER LH

a.
C411729

Remove screws and nuts (arrows).


b.

Guide the rear floor side member cover LH (1) out.


Hide 57627G 2.REMOVE REAR FLOOR SIDE MEMBER COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 58252 3.REMOVE REAR FLOOR PANEL BRACE

CAUTION:

Driving without the rear floor panel brace is not permitted.


a.
A513712

Loosen bolts (1).


b.

Loosen T20 bolts (2).


c.

Unscrew the E14 bolts (3) on the rear lowersuspension member stopper and remove the rear floor panel brace (4).


Hide 58724G 4.REMOVE REAR UNDERBODY PROTECTOR LH

a.
C411722

Loosen screws (1).


b.

Remove the rear underbody protector LH (2).


Hide 58723F 5.REMOVE REAR UNDERBODY PROTECTOR RH

HINT:

Use the same procedure as for the LH side.


Hide 6.REMOVE EXHAUST PIPE ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.


·

Component with heavy weight.

Danger of injury!

-

Note component's center of gravity.

-

Support component using a jack.

-

Secure component against falling off the jack.


·

Heavy component.

Heavy components can lead to injury or damage.

-

Remove and install heavy components with the aid of another person/other persons.




a.
A442390

Unlock plug connection (1) and disconnect.


b.
A442386

Loosen nuts (1).


c.
A442385

Loosen nuts (1).


d.
A442387

Unfasten nut (1).


e.
A442388

Unfasten nut (1).


f.

for Ribbon Clamp:

i.
A442389

Unscrew nut (2) on the exhaust pipe assembly (1).


ii.

Lower the exhaust pipe assembly (1) with an auxiliary person, guide out and remove.



g.
A442369

for V-band Clamp:

i.

Using a 16 mm deep socket wrench, loosen exhaust pipe clamp (1).


ii.

Lower the exhaust pipe assembly with an auxiliary person, guide out and remove.