77350
1.REMOVE FUEL FILLER OPENING LID ASSEMBLY
Unlock the latch mechanism (1) with a screwdriver.
Remove the fuel filler opening lid assembly (2) from the hinge in the direction of the arrow.
77305A
2.REMOVE FUEL FILLER OPENING LID SUB-ASSEMBLY
Disconnect the retaining strap (1) in the direction of the arrow.
Remove fuel tank cap assembly (2).
Pierce the fuel filler opening lid sub-assembly (1) in the highlighted areas (2) using a small screwdriver.
The fuel filler opening lid sub-assembly (1) will not be reused.
Use pliers to hold the cover bowl under tension.
Insert the screwdriver no more than 10 mm (0.394 in.) deep.
Unlock the claws in a sequence from (1) to (4) with a screwdriver in the direction of the arrows.
Remove the fuel filler opening lid sub-assembly from the rear side panel.
Unlock connector (2) and disconnect.
Close the fuel filler flap and remove the fuel filler opening lid sub-assembly (1).