Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388308 IGNITION COIL AND SPARK PLUG A

B48 ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SPARK PLUG

Hide 2.INSTALL IGNITION COIL ASSEMBLY

a.
A442142

Install the ignition coil assembly (1) in the direction of the arrow.


b.

Tighten down E8 bolt (2).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect and lock the connector (3).

HINT:

The connector (3) must engage audibly.



d.
A442114

Turn the sound insulation (2) at the pivot point (1) to the installation position and guide it in where marked (arrows).


Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY