Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › SERVO MOTOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388343 SERVO MOTOR A

B58 ENGINE CONTROL  SERVO MOTOR  INSTALLATION  


PROCEDURE

Hide 15330G 1.INSTALL SERVO MOTOR

a.
A441638

Pull off O-ring (1) and replace.


b.
A441283

Push the O-ring (1) onto the servo motor housing to the limit position.


c.
A441284

Clean sealing surface (1).


d.
A441208

Slide servo motor for eccentric shaft (1) up to the limit position.


e.

Turn screw on the servo motor for the eccentric shaft (1) to the right with a 4 mm hexagon wrench (2) until the servo motor for the eccentric shaft rests against the cylinder head.


f.
A441281

Tighten the T30 bolts (1).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


g.

Lock connector.


h.

Position the ventilation line on the intake manifold and lock.


Hide 22030 2.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 12180E 4.INSTALL OIL FILLER CAP ASSEMBLY