57628E
1.REMOVE REAR FLOOR SIDE MEMBER COVER LH
Remove screws and plastic nuts (arrows).
Guide the rear floor side member cover LH (1) out.
57627G
2.REMOVE REAR FLOOR SIDE MEMBER COVER RH
Use the same procedure as for the rear floor side member cover LH.
58252
3.REMOVE REAR FLOOR PANEL BRACE
Driving without the rear floor panel brace or rear lower suspension member stopper is not permitted.
Loosen bolts (1).
Loosen T20 bolts (2).
Unscrew the E14 bolts (3) on the rear lowersuspension member stopper and remove the rear floor panel brace (4).
58724G
4.REMOVE REAR UNDERBODY PROTECTOR LH
Loosen screws (1).
Remove the rear underbody protector LH (2).
58723F
5.REMOVE REAR UNDERBODY PROTECTOR RH
Use the same procedure as for the LH side.
6.REMOVE EXHAUST PIPE ASSEMBLY
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Component with heavy weight.
Danger of injury!
Note component's center of gravity.
Support component using a jack.
Secure component against falling off the jack.
Heavy component.
Heavy components can lead to injury or damage.
Remove and install heavy components with the aid of another person/other persons.
Unlock plug connection (1) and disconnect.
for Ribbon Clamp:
Detach the tail No. 1 exhaust pipe clamp (1).
for V-band Clamp:
Loosen V-band clamp (1).
Unscrew the nuts (1) on the holder (2).
Unscrew the nuts (1) on the holder (2).
Unscrew the nut (1) on the holder (2).
Unscrew the nut (1) on the holder (2).
Guide the exhaust system (1) out with an auxiliary person and remove.