Home › Engine / Hybrid System › B58 (FUEL) › FUEL TUBE (for Front)
RM3650E _51 Engine / Hybrid System _080099 B58 FUEL _0388621 FUEL TUBE(for Front) A

B58 FUEL  FUEL TUBE(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on fuel system.

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.


·

On releasing high pressure line, fuel may emerge at high speed.

Danger of injury!

-

Wear suitable personal protective equipment.

-

Allow the cooling system to cool down to a temperature below 40°C before starting installation work.

-

Note warnings on cylinder head cover.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 12602D 3.REMOVE NO.2 ENGINE COVER SUB-ASSEMBLY

a.
A442245

Guide out and remove the cover of the high pressure pump (1).


Hide 23801P 4.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

CAUTION:
·

Working on fuel system.

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A442248

Unlock and disconnect the plug connections (1) and (2).


b.

Unlock the locks (3).


c.

Guide out the wiring harness section of the engine wiring harness (4) and set it aside.


d.
A442249

Unscrew union nuts (arrows) with the 17 mm union nut wrench.


e.

Catch and dispose of escaping fuel.


f.

Thread out the No. 1 fuel pipe sub-assembly (4) from the bracket (3) and remove it.