Home › Engine / Hybrid System › B48 (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR
RM3650E _51 Engine / Hybrid System _080100 B48 EMISSION CONTROL _0388636 DIFFERENTIAL PRESSURE SENSOR A

B48 EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

HINT:
·

Check the pressure hose on the pressure sensor and/or the differential pressure sensor. Replace hardened pressure hose.

·

Check connection on pressure pipe and pressure sensor for leaks.



a.

Thread in differential pressure sensor (3) on the holder (4) and install.

HINT:

The differential pressure sensor (3) must engage audibly.



b.
A441468

Check the pressure hose (2) for damage and renew where required.

HINT:

The pressure hose (2) must not be hardened or damaged.



c.

Push the pressure hose (2) in the direction of arrow till the limit position on the differential pressure sensor (3).


d.

Connect and lock the connector (1).

HINT:

The connector (1) must engage audibly.



e.
A441466

Guide in and install sensor cover (2).

HINT:

The cover (2) must engage audibly into the locks (arrows).



f.

Tighten down E6 screw (1).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY