Home › Power Source / Network › B48 (BATTERY / CHARGING) › GENERATOR WIRE
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0388701 GENERATOR WIRE A

B48 BATTERY / CHARGING  GENERATOR WIRE  INSTALLATION  


PROCEDURE

Hide 82261A 1.INSTALL GENERATOR WIRE

CAUTION:
·

Improper routing of the generator wire.

·

Risk of short circuits!

-

Route the generator wire without abrasions and do not trap.




a.
A441486

Insert and install the generator wire (1).


b.

Secure the clamps (arrows).


c.
A442171

Clip in the generator wire in the marked areas.


d.
A442136

Insert and install the generator wire (2) to the generator assembly.


e.

Tighten nut (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


f.
A442134

Guide the radiator reserve tank hose, No.2 radiator hose and water by-pass hose (1) with the holder in and install.

HINT:

The lock must audibly engage.



g.
A442133

Insert and install the generator wire (3) to the positive battery terminal.


h.

Secure clamp (2).


i.

Tighten nut (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


j.
A441479

Insert and install the terminal cover (2) in the direction of the arrow.

HINT:

The locks (1) must engage audibly.



Hide 11271A 2.INSTALL REAR CYLINDER BLOCK COVER

Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55788A 7.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 53681 8.INSTALL UPPER FRONT SUSPENSION CENTER BRACE

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL