Home › Power Source / Network › B48 (BATTERY / CHARGING) › SAFETY BATTERY TERMINAL
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0388703 SAFETY BATTERY TERMINAL A

B48 BATTERY / CHARGING  SAFETY BATTERY TERMINAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SAFETY BATTERY TERMINAL

a.
A442168

Install the safety battery terminal (3) and position on the positive battery terminal.


b.

Secure the holder (1).


c.

Tighten nut (2).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


d.
A442167

Position the No. 4 floor wire (2) on the safety battery terminal.


e.

Tighten nut (1).

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


f.

Close the cover of the safety battery terminal.


g.
A442165

Position the No. 4 floor wire (2) on the power distribution box.


h.

Tighten nut (1).

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


i.
A442170

Position the cover (1) and clip into the marked areas.


j.
A442169

Position cable (2).


k.

Clip in the holder (1).


l.
A442163

Position the cable (3) and clip in the holder (1).


m.

Connect connectors (2) and lock.


n.
A513451

Clip protective cap(1) into latch mechanisms(2) in direction of arrow.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL