51219
1.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR
Position front suspension member lower protector (1).
Replace 16 mm bolts (2).
Tighten the 16 mm bolts (2).
Using SST, tighten the 16 mm bolts (2) an additional 45°.
| *a | Example |
| *b | Before Tightening |
| *c | After Tightening |
| *d | Magnetic Portion |
The magnetic portion is used to secure the gauge to the vehicle.
After first adjusting the needle of the gauge to 0°, tighten to the specified angle.
Perform the work procedure carefully so that the gauge, etc. does not become tilted.
Tighten screws (arrows).
50819
2.INSTALL FRONT FLOOR COVER
Position front floor cover (1).
Tighten screws (arrows).
53896B
3.INSTALL FRONT FENDER SPLASH FRONT SHIELD LH
Insert the front fender splash front shield LH (1) at the side.
Tighten screws (arrows).
53895B
4.INSTALL FRONT FENDER SPLASH FRONT SHIELD RH
Use the same procedure as for the LH side.
51410
5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Guide the No. 1 engine under cover assembly (1) in and position it.
Tighten screws (arrows).