Home › General › SPECIFICATIONS › B58 ENGINE MECHANICAL
RM3650E _V1 General _079878 SPECIFICATIONS _0388855 B58 ENGINE MECHANICAL F

SPECIFICATIONS  B58 ENGINE MECHANICAL  SERVICE DATA  


ENGINE
Ignition timing Minimum standard compression pressure 900 kPa (9.2 kgf/cm2, 131 psi)
Maximum pressure difference between each cylinder 250 kPa (2.5 kgf/cm2, 36 psi)

CRANKSHAFT
Crankshaft Thrust clearance Maximum 0.09 to 0.314 mm (0.0035 to 0.0124 in.)
Coefficient of friction Maximum 12 N*m (122 kgf*cm, 9 ft.*lbf)

PISTON
Piston Diameter Distance (A) to the lowerend of the piston skirt 14 mm (0.551 in.) Standard 81.938 to 81.956 mm (3.226 to 3.227 in.)
Distance (A) to the lowerend of the piston skirt 26 mm (1.02 in.) Standard 81.870 to 81.884 mm (3.223 to 3.224 in.)
Distance (A) to the lowerend of the piston skirt 49 mm (1.93 in.) Standard 81.285 to 81.309 mm (3.200 to 3.201 in.)
Cylinder bore Diameter Distance from the upperedge of the cylinder barrelto the measuring point 0 to 60 mm (0 to 2.36 in.) Standard 82.000 to 82.014 mm (3.228 to 3.229 in.)
Distance from the upperedge of the cylinder barrelto the measuring point 60 to 80 mm (2.36 to 3.15in.) Standard 82.008 to 82.022 mm (3.2287 to 3.2292 in.)
Distance from the upperedge of the cylinder barrelto the measuring point 80 to 115 mm (3.15 to4.53 in.) Standard 82.021 to 82.037 mm (3.2292 to 3.2298 in.)
Distance from the upperedge of the cylinder barrelto the measuring point 115 to 135 mm (4.53 to5.31 in.) Standard 82.033 to 82.057 mm (3.230 to 3.231 in.)