13711E
1.INSTALL VALVE STEM OIL SEAL
Remove oil and dirt from the contact surface (1).
Replace the valve stem oil seal (1).
Make sure that the special tool 0 490 797 (11 1 960) is used when installing the valve stem oil seal.
Guide in and install the special tool 0 490 797 (11 1 960) on valve (1).
Guide in and install valve stem seal (1) on the special tool 0 490 797 (11 1 960).
Guide the special tool 0 490 797 (11 1 960) out and remove.
Press the valve stem oil seal (1) onto the cylinder head till the limitposition using special tool 0 493 249 (11 6 380).
Ensure that valve stem oil seal (1) is positioned correctly on cylinder head sub-assembly (2).
2.INSTALL COMPRESSION SPRING