Home › Steering › STEERING COLUMN › STEERING COLUMN COVER
RM3650E _55 Steering _080257 STEERING COLUMN _0389217 STEERING COLUMN COVER A

STEERING COLUMN  STEERING COLUMN COVER  REMOVAL  


PROCEDURE

Hide 1.ADJUST STEERING COLUMN POSITION

a.

Adjust the length of the steering column to the maximum length.


b.

Move the steering column to the lowest steering column position.


Hide 45286B 2.REMOVE UPPER STEERING COLUMN COVER

a.
C416092

Using a moulding remover A, unclip the gap cover (1) from the clips (2) to the top.


b.
C413484

Turn the steering wheel until the rubber plug (1) in the lower steering column cover becomes visible.

HINT:

Use the same procedure for the opposite side.



c.

Press in the rubber plug (1) with the T15 "TORX" driver to the inside and into the lower steering column cover.

HINT:
·

Use the same procedure for the opposite side.

·

The rubber plugs are reusable.

·

Process to reuse the rubber plug:

Remove the steering column shroud lower section and remove the rubber plug.




d.
C413485

Press the "TORX" driver (1) in the direction of the arrow and lever the tab (2) to the inside.

HINT:

Use the same procedure for the opposite side.



e.

Press the upper steering column cover (3) to the top at the same time.

HINT:

Use the same procedure for the opposite side.



f.
C413489

Guide the upper steering column cover (1) out to the top.


Hide 45287 3.REMOVE LOWER STEERING COLUMN COVER

a.
C413490

Push the retaining lug (1) to the outside in the direction of the arrow and unclip the lower steering column cover (2) in the direction of the arrow to the bottom.

HINT:

Use the same procedure for the opposite side.



b.
C413491

Tilt the lower steering column cover (1) down.


c.

Unlock plug connection (2) and disconnect.


d.

Disconnect the cable clip (3) and remove the lower steering column cover (1).


e.
C417461

Remove rubber plugs (1) from the lower steering column cover.