Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389257 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  REASSEMBLY  


PROCEDURE

Hide 41181H 1.INSTALL REAR DIFFERENTIAL CARRIER COVER

NOTICE:
·

The application time of the liquid sealing compound can be at a maximum of 10 min.

·

Start-up of the assembly is not possible until 25 minutes after the application time.

·

Non-observance can lead to leaks in the assembly.



a.

Load the sealer gun with the seal packing.

Seal Packing:

Loctite 5970 Flange Sealant



b.
C413553

Apply liquid sealing compound along the dotted line (1) on the sealing surface of the rear differential carrier assembly.

NOTICE:

The sealing bead must run along the inner edge.



c.
C413554

Position the rear differential carrier cover on the rear differential carrier assembly.


d.

Tighten the T55 bolts (1).

Torque:
140 N*m (1428 kgf*cm, 103 ft.*lbf)