Home › General › MAINTENANCE › TIRE AND WHEEL
RM3650E _V1 General _079881 MAINTENANCE _0393015 TIRE AND WHEEL A

MAINTENANCE  TIRE AND WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS




PROCEDURE

Hide 1.REMOVE WHEEL ASSEMBLY

a.

Loosen the axle hub bolts approximately 90°.


b.

Lift up the vehicle.


c.
C414180

Remove the axle hub bolt and then install SST (1) to the hole where the axle hub bolt was removed as shown in the illustration.

SST
09650-14010  

NOTICE:
·

Place the mounting position of SST at the top.

·

Be sure to screw in the thread of SST completely.




d.

Remove the 4 remaining axle hub bolts and then use SST as a guide to remove the wheel assembly.

HINT:

Because this vehicle does not have wheel studs, SST is used as a guide to assist with removal and installation of the wheel assembly.



e.

Remove SST.