BATTERY PRECAUTION
Do not exceed the maximum charging voltage of 14.8 V when charging an battery!
Do not use rapid-charging!
Recommended temperature for charging 15 to 25°C
The battery is sufficiently charged when the charge current drops below 2.5 amperes.
Do not connect the battery charger to the 12 V power socket!
Only charge the battery via the jump starting positive battery terminal point.
Note for Service:
Do not open battery.
Caution! Danger of destruction to battery state sensor assembly and wiring upon battery replacement:
Do not introduce any additional connections at the battery negative terminal.
Do not modify the earth wire.
Do not use force when disconnecting the earth wire from the battery terminal.
Do not place any tools under the battery state sensor assembly to lever off the earth wire.
Do not use battery state sensor assembly connections as levers.
Avoid contact between battery state sensor assembly and ground.
Only exchange the battery state sensor assembly when there is a corresponding fault code entry!