Home › General › INTRODUCTION › HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS
RM3650E _V1 General _080075 INTRODUCTION _0402842 HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS C

INTRODUCTION  HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS  ISTA  How to connect the diagnosis system  


CAUTION / NOTICE / HINT

Connect the ISTA interface cable to the diagnosis system itself before connecting it to the vehicle.

DTC DETECTION CONDITION

DTC No. Detection Item
ISTA How to connect the diagnosis system

PROCEDURE

1.Connect the battery charger to the vehicle.
Result:
Proceed to
NEXT



NEXT

2.Connect the ISTA interface cable to the diagnosis system.
2.Connect the ISTA interface cable to the diagnosis system.
Result:
Proceed to
NEXT



NEXT

3.Connect the ISTA interface cable to the DLC3.
3.Connect the ISTA interface cable to the DLC3.
Result:
Proceed to
NEXT



NEXT

4.Turn the diagnosis system on.
4.Turn the diagnosis system on.
Result:
Proceed to
NEXT



NEXT

Press the START-STOP button (engine switch) 3 times within 0.8 seconds to enter Diagnostic (PAD) Mode.