Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM3650E _55 Steering _080256 STEERING GEAR / LINKAGE _0389212 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 1. NOTES ON REPLACEMENT OF STEERING GEAR FOLLOWING ACCIDENT DAMAGE

a.

In the event of accidents or driving conditions similar to accidents, shock-like loads can cause different types of damage to steering gear assembly. When a steering gear assembly is externally undamaged, it is sometimes only possible to identify damage with great difficulty and with great effort. However, damage of this nature poses an unacceptable risk to the vehicle because it can result in failure of the steering system. Because of the disproportionate amount of effort involved, it is generally not sensible to check thoroughly all the individual components of the steering gear assembly and as an alternative it is necessary to take into account other components which can be checked more easily.


Hide 2. PROCEDURE FOR STEERING GEAR

a.

The steering gear assembly must be renewed if one or more of the following points apply.

i.

Visible or noticeable damage to the steering gear assembly, the associated plug connections or the control unit


ii.

Impermissible increase in torque and clamping when cranking the steering gear assembly from limit position to limit position (without electrical support)


iii.

Fire damage


iv.

Damage, permanent deformation or breakages on wheel rims


v.

Damage, permanent deformation or breakages on shock absorber assemblies, steering knuckles or axle hubs


vi.

Damage, permanent deformation or breakages on suspension arms, rear floor panel brace or on the stabiliser


vii.

Damage, permanent deformation or breakages on body side attachment points of wheel guide parts


viii.

Damage, permanent deformation or breakages on front suspension crossmember sub-assembly


ix.

Damage, permanent deformation or breakages on tie rod end sub-assemblies


x.

Damage, permanent deformation or breakages on steering gear mounting


xi.

Damage, permanent deformation or breakages on steering column



b.

A lopsided steering wheel, significant deviations of camber/track values and noises when cranking the steering can be additional indications for the damage/deformations listed here.