Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389247 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  INSPECTION  


PROCEDURE

Hide 1. NOTES ON WHEEL BEARING REPLACEMENT FOLLOWING ACCIDENT DAMAGE

a.

In the event of accidents or driving conditions similar to accidents, shock-like loads to the wheel bearing units can cause slight damage to the bearing track. Despite initial running without noise, with continued use, this results in later noise generation at the wheel bearing.


Hide 2. PROCEDURE FOR WHEEL BEARING

a.

The wheel bearing must be replaced on the damaged side of the axle if one or several of the following points apply.

i.

Visible or noticeable damage to the wheel bearing


ii.

Rolling noises, radial/lateral runout on the wheel bearing


iii.

Permissible tolerance for the wheel alignment is exceeded and no longer adjustable without the exchange of additional components


iv.

Damage, permanent deformation or breakages on wheel rims (severe damage) and simultaneous negative result of the wheel alignment


v.

Damage, permanent deformation or breakages on shock absorber assemblies, steering knuckles or axle hubs


vi.

Damage, permanent deformation or breakages on suspension arms


vii.

Damage, permanent deformation or breakages on pressure and rear floor panel brace or stabilisers with this function


viii.

Damage, permanent deformation or breakages on body side attachment points of wheel guide parts


ix.

Damage, permanent deformation or breakages on tie rod end sub-assemblies


x.

Damage, permanent deformation or breakages on steering gear mounting