Home › General › INTRODUCTION › REPAIR INSTRUCTION
RM3650E _V1 General _080075 INTRODUCTION _0392757 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INSPECTION MODE PROCEDURE  


INSPECTION MODE


HINT:

Due to the adoption of VSC/TR(A)C, when using a speedometer tester, it is necessary to enter chassis dyno mode to cancel VSC/TR(A)C.


Mode Purpose Control
Chassis Dyno Mode For performing tests using a speedometer tester, two-wheel chassis dynamometer, four-wheel chassis dynamometer, etc. Cancels VSC/TR(A)C control


ACTIVATING CHASSIS DYNO MODE


a.

Press the START-STOP button (engine switch) 3 times within 0.8 seconds to enter Diagnostic (PAD) Mode.

HINT:

After entering Diagnostic (PAD) Mode, "Diagnostic mode active." is displayed in the combination meter.


D225732


b.

Press and hold the trip distance recorder reset button for approximately 15 seconds until "MAIN MENU" is displayed.

D225698C01
0.521,2.51 0.823,2.51 true 0.354,2.438 0.667,2.594 0.313,0.156 10 false *a
*a Trip Distance Recorder Reset Button - -



c.

Briefly press the trip distance recorder reset button to change the "MAIN MENU" item to "Chassis dyno".

D225699C01
0.521,2.51 0.823,2.51 true 0.354,2.438 0.667,2.594 0.313,0.156 10 false *a
*a Trip Distance Recorder Reset Button - -



d.

Press and hold the trip distance recorder reset button to execute "Chassis dyno".

HINT:

After executing "Chassis dyno", "Start dyno mode/VSC OFF?" is displayed in the combination meter.


D225700C01
0.521,2.51 0.823,2.51 true 0.354,2.438 0.667,2.594 0.313,0.156 10 false *a
*a Trip Distance Recorder Reset Button - -



e.

Briefly press the trip distance recorder reset button to enter chassis dyno mode.

HINT:

When "Test mode! End: switch off ignition." is displayed in the combination meter, the system is in chassis dyno mode.


D225733C01
0.521,2.51 0.823,2.51 true 0.354,2.438 0.667,2.594 0.313,0.156 10 false *a
*a Trip Distance Recorder Reset Button - -



f.

Depress the brake pedal and start the engine, and then perform the inspection.



DEACTIVATING CHASSIS DYNO MODE


a.

Turn the START-STOP button (engine switch) off.