Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM


E120415E01


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    I045102E01
  1. Check the resistance.

    Standard:
    Built-in AMP

    Tester Connection
    Condition
    Specified Condition
    GND (R1-7) - Body ground
    Constant
    Below 1Ω

    Standard:
    Separate AMP

    Tester Connection
    Condition
    Specified Condition
    GND (R1-20) - Body ground
    Constant
    Below 1Ω

  1. Turn the ignition switch to the ACC position.



    I044826E01
  1. Measure the voltage.

    Standard:
    Built-in AMP

    Tester Connection
    Condition
    Specified Condition
    B (R1-4) - GND (R1-7)
    Constant
    10 to 14 V
    ACC (R1-3) - GND (R1-7)
    Ignition switch ACC or ON
    10 to 14 V

    Standard:
    Separate AMP

    Tester Connection
    Condition
    Specified Condition
    B (R1-1) - GND (R1-20)
    Constant
    Below 1Ω
    ACC (R1-11) - GND (R1-20)
    Ignition switch ACC or ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE