SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE (Using an intelligent tester) |
![]() |
Check and ensure the following conditions:
Battery voltage 11 V or more
Throttle valve fully closed
Transmission in the P or N positions
A/C switched OFF
Turn the ignition switch OFF.
Connect an intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / CHECK MODE.
Switch the ECM from normal mode to check mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check DTCs and freeze frame data using the tester.