Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the CRUISE CONTROL MAIN switch is turned off, cruise control does not operate.

WIRING DIAGRAM


B125023E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY)


    I101322E01
  1. Turn the ignition switch off.

  1. Disconnect the E7 ECM connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage (1GR-FE):
    Tester connection
    Condition
    Specification
    PI (E7-18) - Body ground
    Ignition ON
    10 to 14 V

    Standard Voltage (2TR-FE):
    Tester connection
    Condition
    Specification
    PI (E7-18) - Body ground
    Ignition ON
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    I101310E04
  1. Turn the ignition switch off.

  1. Disconnect the E7 ECM connector.

  1. Disconnect the combination meter C9 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specification
    C9-24 - PI (E7-18)
    Always
    Below 1Ω
    C9-24 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY)


    I044513E11
  1. Disconnect the C9 combination meter connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester connection
    Condition
    Specification
    C9-21 - Body ground
    Ignition ON
    10 to 14 V

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - BATTERY)
OK

REPLACE COMBINATION METER ASSEMBLY