Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST
  1. While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.

    ECM (Cruise control): 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    VEHICLE SPD
    Vehicle speed / min.: 0 mph(0 km/h), max.: 158 mph (255 km/h)
    Actual vehicle speed
    -
    MEMORY SPD
    Cruise control memorized speed / min.: 22.5 mph (36 km/h), max.: 125 mph(200 km/h)
    Actual stored vehicle speed
    -
    CRUISE CONTROL
    Cruise control system active condition / ON or OFF
    ON: Cruise control activated
    OFF: Cruise control inactivated
    -
    MAIN SW (MAIN)
    Main switch signal (Main CPU) / ON or OFF
    ON: Main switch ON (Pushed on)
    OFF: Main switch OFF (Pushed off)
    "3"
    MAIN SW (SUB)
    Main switch signal (Sub CPU) / ON or OFF
    ON: Main switch ON (Pushed on)
    OFF: Main switch OFF (Pushed off)
    "3"
    CCS READY M
    Cruise control system standby condition (Main CPU) / ON or OFF
    ON/OFF: Change ON/OFF each main switch is pushed in
    "1"
    CCS READY S
    Cruise control system standby condition (Sub CPU) / ON or OFF
    ON/OFF: Change ON/OFF each main switch is pushed in
    "1"
    CCS INDICATOR M
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CCS READY" ON
    OFF: "CCS READY" OFF
    "2"
    CANCEL SW
    CANCEL switch signal / ON or OFF
    ON: CANCEL switch ON
    OFF: CANCEL switch OFF
    -
    -/SET SW
    -/SET switch signal / ON or OFF
    ON: SET / COAST switch ON
    OFF: SET / COAST switch OFF
    -
    +/SET SW
    +/SET switch signal / ON or OFF
    ON: RES / ACC switch ON
    OFF: RES / ACC switch OFF
    -
    STP LIGHT SW M
    Stop light switch signal (Main CPU) / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    STP LIGHT SW S2
    Stop light switch-2 signal (Sub CPU) / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    STP LIGHT SW S1
    Stop light switch-1 signal (Sub CPU) / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    SHIFT D POS
    PNP switch signal (D position) / ON or OFF
    ON: Shift lever on D
    OFF: Shift lever not on D
    -

    HINT:
    1. "3" is OK but "1" is NG → ECM failure
    2. "1" is OK but "2" is NG → DTC output or ECM failure
    3. "3" is OK but CRUISE indicator does not come on → CRUISE main indicator, wire harness or ECM failure