Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. DRAIN ENGINE COOLANT


A070279E01

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. Remove the service hole cover from the engine under cover.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.



    A076320E02
  1. Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Remove the radiator cap.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


4. REMOVE V-BANK COVER


A075593E01
  1. Remove the 2 nuts, then remove the V-bank cover.



5. REMOVE AIR CLEANER ASSEMBLY


A075594E01
  1. Disconnect the ventilation hose No. 2.



    A075595E01
  1. Disconnect the vacuum hose.

  1. Disconnect the mass air flow meter connector.

  1. Remove the 2 wire harness clamps.



    A075596E01
  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts, then remove the air cleaner.



6. REMOVE INTAKE AIR SURGE TANK


A075597E01
  1. Disconnect the water by-pass hose No. 5.



    A075598E01
  1. Disconnect the water by-pass hose No. 4.



    A075644E01
  1. Disconnect the fuel vapor feed hose.



    A075645E01
  1. Disconnect the ventilation hose.



    A075646E01
  1. Disconnect the 2 VSV connectors.

  1. Disconnect the throttle motor connector.

  1. Remove the 3 wire harness clamps and hose clamp.



    A075647E01
  1. Remove the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.



    A075648E02
  1. Using an 8 mm socket hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts, then remove the intake air surge tank and gasket.



7. DISCONNECT FUEL PIPE SUB-ASSEMBLY NO.2


A121824E01
  1. Remove the fuel pipe clamp.

  1. Pinch the tube connector, and then pull the fuel pipe out of the pipe as shown in the illustration.

    NOTICE:
    1. Remove any dirt and foreign objects from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel tube.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.



8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


G036120E01
  1. Disconnect the connector.

  1. Using a 19 mm deep socket wrench, remove the water temperature sensor and gasket.