Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here


NOTICE:
  1. Perform the RESET MEMORY (AT initialization) and when replacing the automatic transmission assembly, engine assembly or ECM (Click here).
  2. Perform the REGISTRATION (VIN registration) when replacing the ECM (Click here).
  3. If the ECM has replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning lamp (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B085785E01
  1. Disengage the claw and separate the glove compartment door stopper from the glove compartment door assembly.

  1. Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.



    B085786E01
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.



3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER RH


    B085787E01
  1. Remove the bolt <B>.

  1. Disengage the 2 clips and remove the instrument panel lower finish panel sub-assembly RH.



4. REMOVE ECM


G036184E01
  1. Disconnect the 5 connectors.

  1. Remove the 2 bolts and nut, then remove the ECM.



5. REMOVE ECM BRACKET


G036186E01
  1. Remove the 3 screws, then remove the ECM bracket.



6. REMOVE ECM BRACKET NO.2


G036187E01
  1. Remove the 2 screws, then remove the ECM bracket No. 2.