FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD.
Check the fuel operation by operating it with the intelligent tester.
If the fuel pump does not operate, replace the fuel pump.
| 2. CHECK FUEL PRESSURE |
![]() |
Prepare for the inspection.
Prepare a new fuel tube.
Using a cutter knife, cut the fuel tube protector. Tear the protector by hand, then remove the fuel tube connector.
Discharge the fuel pressure system (Click here).
Using a voltmeter, measure the battery voltage.
Disconnect the battery negative terminal.
Disengage the fuel pipe clamp (Click here).
Disconnect the fuel pipe No. 1.
![]() |
Install SST and the fuel tube connector onto the vehicle.
Wipe off any spilt gasoline.
Connect the cable to the battery negative terminal.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD / ON.
Measure the fuel pressure.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD / OFF.
Check that the fuel pressure does not change for 5 minutes.
Disconnect the intelligent tester from the DLC3.
Disconnect the cable from the battery negative terminal.
Remove SST and the fuel tube connector while being careful to prevent gasoline splashes.
Connect the fuel tube.
| 3. CHECK FOR FUEL LEAKAGE |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD ll / ACTIVE TEST / FUEL PUMP / SPD / ON.
Check that there are no leakage in the fuel system.