Home › ENGINE ยท 2TR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL EXHAUST PIPE ASSEMBLY FRONT


A077857E01
  1. Check the free length.

    1. Using vernier calipers, measure the free length of the compression spring.

      Minimum:
      40.5 mm (1.594 in.)

      If the free length is less than the minimum, replace the compression spring.



    A076194E06
  1. Using a wooden block and plastic-faced hammer, tap in a new gasket until it is flush with the exhaust manifold.

    NOTICE:
    1. Make sure that the gasket is in the correct angle when installing.
    2. Do not reuse the removed gasket.
    3. Never push a new gasket into the exhaust manifold by installing the exhaust pipe front into the exhaust manifold.

  1. Install the exhaust pipe front into the exhaust pipe support.

  1. Tighten the 2 bolts and 2 compression springs.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



2. INSTALL EXHAUST PIPE ASSEMBLY TAIL
  1. Install a new gasket onto the exhaust pipe front.

  1. Install the exhaust pipe tail onto the 4 exhaust pipe supports.

  1. Tighten the 2 bolts and 2 nuts.

    Torque:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }



3. INSTALL OXYGEN SENSOR


G037929E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } with SST

    NOTICE:
    Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).



    G037928E01
  1. Connect the wire harness clamp. (4WD DRIVE TYPE)

  1. Connect the oxygen sensor connector.



4. INSTALL AIR FUEL RATIO SENSOR


G037929E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } with SST

    NOTICE:
    Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).



    G037928E01
  1. Connect the wire harness clamp. (4WD DRIVE TYPE)

  1. Connect the oxygen sensor connector.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



6. CHECK FOR EXHAUST GAS LEAKAGE