FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP & GAGE TUBE ASSEMBLY |
Install a new gasket onto the fuel tank.
Set the fuel pump assembly in the fuel tank.
![]() |
Fit a spline of the fuel suction tube assembly into a keyway of the fuel tank.
![]() |
Install a new retainer.
Align the mark on a new retainer with the rib on the fuel tank as shown in the illustration.
![]() |
Using SST, turn the retainer 740° to 780° clockwise (more than 2 turns), and position the mark on the retainer within range A to install it.
| 2. INSTALL FUEL TANK MAIN TUBE AND FUEL TANK RETURN TUBE |
![]() |
Install the fuel tank main tube and return tube with the 2 joint clips.
| 3. INSTALL FUEL TANK ASSEMBLY |
Set the fuel tank assembly onto the mission jack.
Connect the fuel tank vent hose.
Align the fuel tank vent connector with the pipe, then push in the fuel tank vent connector until the retainer makes a "click" sound to connect the fuel tank vent hose to the fuel suction plate.
Connect the fuel pump connector.
Install the fuel pump cover.
Connect the fuel tank to filler pipe hose.
Install the 2 fuel tank bands.
Install the 2 fuel tank bands with the 2 pins and 2 clips.
Install the 2 fuel tank bands with the 2 bolts.
![]() |
Connect the fuel tank breather tube.
Align the fuel tube connector with the pipe, then push the fuel tube connector in until the retainer makes a "click" sound to connect the fuel tank vent breather tube.
Install the checker onto the pipe.
Tighten the clamp bolt.
| 4. CONNECT FUEL TANK MAIN TUBE AND FUEL TANK RETURN TUBE |
![]() |
Connect the fuel tank main tube and return tube.
Align the fuel tube connector with the pipe, then push the fuel tube connector in until the retainer makes a "click" sound to connect the fuel tank main tube and return tube.
Install the fuel pipe clamp.
| 5. INSTALL NO.1 FUEL TANK PROTECTOR SUB-ASSEMBLY |
Install the fuel tank protector LWR with the 4 nuts.
| 6. ADD FUEL |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. CHECK FOR FUEL LEAKAGE |