Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DATA LIST.


Transponder key ECU assembly 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
KEY SW
Unlock warning switch signal/ ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
IG SW
Ignition switch signal / ON or OFF
ON: Ignition switch ON
OFF: Ignition switch OFF or ACC
-
IMMOBILISER
Immobiliser system status / SET or UNSET
SET: Without key
UNSET: Ignition switch ON
-
PERMIT (START)
Start control system starting control / OK or NG
OK: Start control system starting is permitted
NG: Start control system starting is not permitted
-
RESPONSE
Transponder chip data / OK or NG
OK: Data OK
NG: Data error
-
FRAME
Transponder chip data / OK or NG
OK: Data OK
NG: Data error
-
SERIAL NUMBER
Transponder chip signal / OK or NG
OK: Data OK
NG: Data error
-
ENCRYPT CODE
Transponder chip signal / OK or NG
OK: Data OK
NG: Data error
-
STATUS
Transponder chip signal / OK or NG
OK: Data OK
NG: Data error
-
BCC
Transponder chip signal / OK or NG
OK: Correct data sending
NG: Incorrect data sending
-
SUB KEY
Sub-key code signal / NO MATCH or MATCH
NO MATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent
-
MASTER KEY
Master key code signal / MATCH or NO MATCH
NO MATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent
-
REGIST SUB CODE
Number of registered sub- key / min. 0, max. 15
Number of registered sub-keys
-
REGIST MAS CODE
Number of registered master key / min. 0, max. 15
Number of registered master keys
-
REG CODE SPACE
Memory space for key codes registration / NOT FUL or FULL
NOT FUL: Possible to register more key codes
Full: Cannot register any more key codes
-
+B
+B judgment / NORMAL or BREAK
NORMAL: Battery supply is normal
BREAK: Battery supply is malfunctioning
-
ANTENNA COIL
Antenna coil condition / NORMAL or FAIL
NORMAL: Antenna coil is normal
FAIL: Antenna coil is malfunctioning
-
G-CODE SUPPORT
G code judgment / NOT SUPPORT or SUPPORT
NOT SUPPORT: G-code is not supported
SUPPORT: G-code is supported
-
G-CODE DECISION
G code judgment / YES or NO
-
-
WIRELS C-CODE
REGD or NOT REGD
-
-

PERFORM ACTIVE TEST

HINT:
Perform the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the ACTIVE TEST according to the display on the tester.


Transponder key ECU 
Item
Test Details
Diagnostic Note
SECURITY INDC
Turn security indicator ON/OFF
-