Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD


G035612E02
  1. Check the voltage.

    1. Turn the ignition switch to ON.

    2. Turn the intelligent tester ON.

    3. Start the engine and warm it up.

    4. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / ACCEL POS #1, ACCEL POS #2.

    5. Operate the accelerator pedal, then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specifications.

      Standard:
      ACCELE POS #1:
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V
      ACCELE POS #2:
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal rod, wire harness and ECM.