Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2799    Engine Immobiliser System

for Preparation Click here


DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detected errors in its own communications with the immobiliser code ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the immobiliser code ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no certification ECU DTCs are present. If present, troubleshoot the certification ECU DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799
  1. Error in communication between ECM and transponder key ECU, and in communication line
  2. Communication ID is different during communication with transponder key ECU
  1. Wire harness and connector
  2. ECM

WIRING DIAGRAM


B121684E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - ECM)


    B087954E02
  1. Disconnect the T10 ECU connector.

  1. Disconnect the E7 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T10-13 (EFIO) - E7-16 (IMI)
    Below 1 Ω
    T10-12 (EFII) - E7-15 (IMO)
    Below 1 Ω
    T10-13 (EFIO) or E7-16 (IMI) - Body ground
    10 kΩ or higher
    T10-12 (EFII) or E7-15 (IMO) - Body ground
    10 kΩ or higher

  1. Reconnect the ECU connector.

  1. Reconnect the amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM