IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK IGNITION COIL ASSEMBLY AND PERFORM SPARK TEST |
Check for DTCs.
Check that sparks occur.
Remove the ignition coils.
Using a 16 mm plug wrench, remove the spark plugs.
Install the spark plugs to each ignition coil, and connect the ignition coil connectors.
Disconnect the 6 injector connectors.
Ground the spark plugs.
Check if sparks occur at each spark plug while the engine is being cranked.
Spark test flow chart.
Check that the wire harness side connector of ignition coil with igniter is securely connector.
| Result | Proceed to |
| NG | Connect securely. |
| OK | Go to next step. |
Perform spark test on each ignition coil with igniter.
1.Replace ignition coil with igniter with a normal one.
2.Perform spark test again.
| Result | Proceed to |
| NG | Replace ignition coil with igniter. |
| OK | Go to next step. |
Check power supply to ignition coil.
1.Turn ignition switch ON.
2.Check that there is battery positive (+) voltage at ignition coil positive (+) terminal.
| Result | Proceed to |
| NG | Check wiring between ignition switch and ignition coil assembly. |
| OK | Go to next step. |
Check resistance in VVT sensor out put voltage (see step 2).
| Result | Proceed to |
| NG | Following test 1 and 2. |
| OK | Go to next step. |
| Result | Proceed to |
| NG | Repair wiring between VVT sensor and ECM. |
| OK | Repair VVT sensor |
Check resistance in crankshaft position sensor.
| Standard condition | Specified condition |
| at 20°C (68°F) | 1850 to 2450 Ω |
| Result | Proceed to |
| NG | Replace the crankshaft position sensor. |
| OK | Go to next step. |
Check IGT signal from ECM.
| Result | Proceed to |
| NG | Check ECM |
| OK | Repair wiring between ignition coil and ECM. |
Using a 16 mm plug wrench, install the spark plugs.
Install the ignition coils.
| 2. CHECK SPARK PLUG |
Remove the engine cover.
Remove the air cleaner.
Remove the ignition coil.
Remove the spark plug.
![]() |
Check the electrode.
Using an ohmmeter, measure the insulation resistance.
![]() |
Alternative inspection method:
Quickly accelerate the engine to 4,000 rpm 5 times.
Remove the spark plug.
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage on its threads and insulator.
If there is damage, replace the spark plug. If not, reinstall the spark plug.
| Manufacturer | Spark Plug Type |
| DENSO | K20HR-U11 |
| NGK | LFR6C11 |
![]() |
Check the spark plug electrode gap.