Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > ROAD TEST

for Preparation Click here


HINT:
'SET' and '-', 'RES' and '+', 'ON-OFF' functions share the same switch. Operate the cruise control main switch according to the directions indicated on the switch.


INSPECT 'SET' FUNCTION


    E107085E04
  1. Push the ON-OFF button on.

  2. Drive at the vehicle at a desired speed 25 mph (40 km/h) or higher.

  3. Push down the control switch lever to "-/SET" to set the cruising speed.

  4. After releasing the lever, check that the vehicle cruises at the set speed.


INSPECT '+' FUNCTION


    E123138E01
  1. Set a desired speed as in step 1.

  2. Check that the vehicle speed increases while the control switch lever is pushed up to "+/RES".

  3. Check that the vehicle cruises at the newly set speed when the switch is released.

  4. Momentarily (approximately 0.6 seconds) push up the control switch lever to the "+/RES", and then release it. Check that the vehicle speed increases by approximately 1 mph (1.6 km/h) with each lever operation (Tap-up function).


INSPECT '-' FUNCTION


    E123139E01
  1. Set a desired speed as in step 1.

  2. Check that the vehicle speed decreases while the control switch lever is pushed down to "-/SET".

  3. Check that the vehicle cruises at the newly set speed when the switch is released.

  4. Momentarily (approximately 0.6 seconds) push down the control switch to "-/SET", and then release it. Check that the vehicle speed decreases by approximately 1 mph (1.6 km/h) with each lever operation (Tap-down function).

    HINT:
    1. The cruise control system automatically cancels when the vehicle speed decreases to below 25 mph (40 km/h).


INSPECT 'CANCEL' FUNCTION


    E107087E03
  1. Set a desired speed as in step 1.

  2. Check that the system cancels cruise control when one of the following is conducted:

    1. Depressing the brake pedal

    2. Depressing the clutch pedal (M/T)

    3. Shifting into any position except D and 3 while driving (A/T: 2TR-FE)

    4. Shifting into any position except D and 4 while driving (A/T: 1GR-FE)

    5. Pushing the cruise control main switch ON-OFF button off

    6. Pulling the cruise control switch lever to "CANCEL"


INSPECT ' RES (RESUME)' FUNCTION


    E123138E02
  1. Set a desired speed as in step 1.

    1. After cancelling the cruise control according to any of the above operations except (5), push up the switch lever to "+/RES" at a speed of 25 mph (40 km/h) or higher.

    2. Check that the vehicle resumes the previously set speed.

      HINT:
      The 'RES' function does not resume the set speed when the vehicle speed decreases to below 25 mph (40 km/h).