DTC P0505 Idle Control System Malfunction |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0505 | Idling speed continues to vary greatly from target idling speed (2 trip detection logic) |
|

| Related DTCs | P0505: ISC Function |
| Required Sensors/Components (Main) | ETCS |
| Required Sensors/Components (Related) | Crankshaft position sensor, Engine coolant temperature sensor, and Vehicle speed sensor |
| Frequency of Operation | Continuous |
| Duration | 10 minutes |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Engine | Running |
| Following conditions met: | A and B |
| A. Frequency that both of following conditions 1 and 2 met: | 5 times or more |
| 1. Deviation in engine speed | Less than -100 rpm or more than 150 rpm (when shift position D and A/C OFF) |
| 2. Vehicle condition | Stop after vehicle was driven by 6 mph (10 km/h) or more |
| B. Frequency that both of following conditions 3 and 4 met: | Once |
| 3. Deviation in engine speed | Less than -100 rpm or more than 150 rpm (when shift position D and A/C OFF) |
| 4. IAC flow rate learning value | 0.5 L/sec or less, 6.4 L/sec or more |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed To |
| P0505 | A |
| P0505 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK CONNECTION OF PCV HOSE |
|
| ||||
| OK | |
| 3.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leakage.
|
| ||||
| OK | |
| 4.CHECK THROTTLE VALVE |
Check the throttle valve condition.
|
| ||||
| OK | ||
| ||