Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MULTIPLEX NETWORK BODY ECU)

B125008E01

  1. Disconnect the 1A, 1C, 1F, 1H, 1I and 1K driver side J/B connectors.

  2. Disconnect the B5 multiplex network body ECU connectors.

  3. Measure the voltage and resistance of each of the wire harness side connectors.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    ALTB (1A-6) - Body ground
    L - Body ground
    +B (power system, generator system) power supply
    Always
    10 to 14 V
    ECUB (1C-16) - Body ground
    R - Body ground
    +B (ECUB) power supply
    Always
    10 to 14 V
    GND (1H-18) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    KSW (1K-10) - Body ground
    G-B - Body ground
    Key unlock warning switch input
    No key in ignition key cylinder
    10 kΩ or higher
    Key inserted in ignition key cylinder
    Below 1 Ω
    DCTY (1F-7) - Body ground
    G-Y - Body ground
    Driver side courtesy switch input
    Driver side door closed
    10 kΩ or higher
    Driver side door open
    Below 1 Ω
    PCTY (1I-8) - Body ground
    R-B - Body ground
    Pssenger side courtesy switch input
    Passenger side door closed
    10 kΩ or higher
    Passenger side door open
    Below 1 Ω
    L1 (1I-7) - Body ground
    L1 (1I-18) - Body ground
    L-W - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    Door control switch (master switch or passenger side switch) LOCK
    Below 1 Ω
    UL1 (1I-3) - Body ground
    UL1 (1I-1) - Body ground
    GR - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    Door control switch (master switch or passenger side switch) UNLOCK
    Below 1 Ω
    LSWD (B5-20) - Body ground
    W-R - Body ground
    Driver side door lock position switch input
    Driver side door UNLOCK
    10 kΩ or higher
    Driver side door LOCK
    Below 1 Ω
    LSWP (B5-11) - Body ground
    B-W - Body ground
    Driver side door lock position switch input
    Driver side door UNLOCK
    10 kΩ or higher
    Driver side door LOCK
    Below 1 Ω
    L2 (1I-17) - Body ground
    V - Body ground
    Driver side door key-linked door lock input
    Driver side door key cylinder OFF
    10 kΩ or higher
    Driver side door key cylinder LOCK
    Below 1 Ω
    L2 (1I-4) - Body ground
    V - Body ground
    Passenger side door key-linked door lock input
    Passenger side door key cylinder OFF
    10 kΩ or higher
    Passenger side door key cylinder LOCK
    Below 1 Ω
    UL3 (B5-23) - Body ground
    G-B - Body ground
    Driver side door key-linked door unlock input
    Driver side door key cylinder OFF
    10 kΩ or higher
    Driver side door key cylinder UNLOCK
    Below 1 Ω
    UL2 (1I-19) - Body ground
    P - Body ground
    Passenger side door key-linked door unlock input
    Passenger side door key cylinder OFF
    10 kΩ or higher
    Passenger side door key cylinder UNLOCK
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  4. Reconnect the 1A, 1C, 1F, 1H, 1I and 1K J/B connectors.

  5. Reconnect the B5 multiplex network body ECU connectors.

  6. Measure the voltage of the connectors.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    ACT+ (1H-24) - Body ground
    ACT+ (1H-23) - Body ground
    ACT+ (1F-1) - Body ground
    ACT+ (1H-22) - Body ground
    L-R - Body ground
    Door lock motor LOCK drive output (all doors)
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) OFF
    Below 1 V
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) LOCK
    10 to 14 V
    ACTD (B5-3) - Body ground
    L-B - Body ground
    Door lock motor UNLOCK drive output (driver side doors)
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) OFF
    Below 1 V
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) LOCK
    10 to 14 V
    ACT- (1H-5) - Body ground
    ACT- (1F-2) - Body ground
    ACT- (1H-4) - Body ground
    L-B - Body ground
    Door lock motor LOCK drive output (passenger and rear LH and rear RH side door)
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) OFF
    Below 1 V
    Door control switch (master switch or passenger side switch) or door key cylinder (driver or passenger side) LOCK
    10 to 14 V
    If the result is not as specified, the multiplex network body ECU may have a malfunction.