DTC P0101 Mass Air Flow Circuit Range / Performance Problem |
| DTC No. | DTC Detection Conditions | Trouble Area |
| P0101 | High voltage:
| MAF meter |
| Related DTCs | P0101: Mass air flow Meter rationality |
| Required Sensors/Components (Main) | Mass air flow meter |
| Required Sensors/Components (Related) | Crankshaft position sensor, engine coolant temperature sensor, throttle position sensor |
| Frequency of Operation | Continuous |
| Duration | 10 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0115 - P0118 (ECT sensor) P0120 - P0223, P2135 (TP sensor) P0125 (insufficient ECT for closed loop) P0335 (CKP sensor) P0340, P0341 (CMP sensor) |
| Engine speed | Less than 2,000 rpm |
| Engine coolant temperature | 70°C (158°F) or more |
| Engine speed | More than 300 rpm |
| Mass air flow meter voltage | 0.2 V or more |
| Fuel cut | OFF |
| Mass air flow meter voltage | More than 2.2 V (varies with throttle position sensor voltage) |
| Mass air flow meter voltage | Less than 0.93 V (varies with throttle position sensor voltage) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101) |
Connect a intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC output) | Proceed to |
| P0101 and other DTCs | A |
| P0101 | B |
|
| ||||
| A | ||
| ||