DTC P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0121 | Difference between VTA1 and VTA2 voltages less than 0.8 V, or more than 1.6 V for 2 seconds (1 trip detection logic) |
|
| Related DTCs | P0121: TP sensor rationality |
| Required Sensors/Components (Main) | TP sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | Within 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Either of following conditions A or B set | - |
| A. Ignition switch | ON |
| B. ETCS power | ON |
| TP sensor open/short malfunction (P0120, P0122, P0123, P0220, P0222, P0223 and P2135) | Not detected |
| TP sensor 1 - [TP sensor 2 x 0.8 (corrected by learning value)] | Less than 0.8 V, or more than 1.6 V |
| 1.CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P0121) |
Connect a intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC output) | Proceed to |
| P0121 and other DTCs | B |
| P0121 | A |
|
| ||||
| A | ||
| ||