Home › ENGINE ยท 2TR-FE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. DISCONNECT FUEL HOSE


G037900E01
  1. Pull the checker of the fuel hose upward.

  1. Pinch the detaching switch of the fuel hose connector and pull out the fuel hose.

    NOTICE:
    1. Remove any dirt and foreign objects on the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.

    3. G037901E01
      Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel hose.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.



3. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


G037905E01
  1. Remove the 2 bolts, then remove the fuel pressure pulsation damper.