STEERING PAD > DISPOSAL |
![]() |
| 1. DISPOSE OF STEERING PAD ASSEMBLY (WHEN SCRAPPING VEHICLE DEPLOYMENT METHOD) |
![]() |
![]() |
Check the function of the SST.
![]() |
Connect the SST to the battery.
Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the battery negative (-) terminal.
![]() |
Check the SST function.
Press the SST activation switch, and check that the LED of the SST activation switch comes on.
Disconnect the SST from the battery.
![]() |
Install the SST.
While turning the steering wheel right / left, remove the 2 screws and column lower cover.
Disconnect the airbag connector of the spiral cable.
![]() |
Connect the connectors of the 2 SSTs to the airbag connector of the spiral cable.
![]() |
Move the SST at least 10 m (33 ft) away from the front of the vehicle.
Close all the doors and windows of the vehicle.
Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the negative (-) terminal.
Deploy the airbag.
Confirm that no one is inside the vehicle or within 10 m (33 ft) area around the vehicle.
Press the activation switch of the SST and deploy the airbag.
Dispose of the steering pad.
| 2. DISPOSE OF STEERING PAD (WHEN DISPOSING OF AIRBAG ASSEMBLY DEPLOYMENT METHOD) |
Remove the steering pad (Click here).
![]() |
Using a service-purpose wire harness for the vehicle, tie the steering pad assembly to the disc wheel.
![]() |
Install the 2 bolts with washers in the 2 bolt holes in the steering pad.
![]() |
After connecting the following to SST, connect them to the steering pad.
![]() |
Using 3 wire harnesses, wind each one at least 2 times around the bolts installed on the left and right sides of the steering pad.
![]() |
Face the upper surface of the steering pad upward. Separately tie the left and right sides of the steering pad to the disc wheel through the hub nut holes. Position the steering pad connector so that it hangs downward through a hub hole in the disc wheel.
![]() |
Check the function of the SST (See step 1-(a)).
![]() |
Install the SST.
Connect the connector of the SST.
![]() |
Move the SST to at least 10 m (33 ft) away from the steering pad tied down on the disc wheel.
![]() ![]() |
Cover the steering pad with a cardboard box or tires.
![]() |
Deploy the airbag.
Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the battery negative (-) terminal.
Check that no one is within 10 m (33 ft) area around the disc wheel which the steering pad is tied to.
Press the activation switch of the SST and deploy the airbag.
![]() |
Dispose of the steering pad.
Remove the steering pad from the disc wheel.
Place the steering pad in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts disposal.