REAR AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL REAR AIRBAG SENSOR |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the rear airbag sensor with the nut.
| 2. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH |
![]() |
Check the amount of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any directions. Also check that the belt locks when inclination of the retractor is 45° or more.
![]() |
Hook the lower stay of the retractor onto the 2 body hooks.
Tighten bolt A, and then tighten bolt B.
![]() |
Install the shoulder anchor with the bolt.
Check that the shoulder anchor rotates smoothly.
![]() |
Install the floor anchor with the bolt.
Check the ELR lock.
With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the rear seat outer belt.
Remove the bolt and floor anchor.
| 3. INSTALL QUARTER INSIDE TRIM BOARD LH |
![]() |
Engage the 2 clips and install the quarter inside trim board.
Tighten the 3 screws.
![]() |
Engage the claw and close the cover.
![]() |
Install the floor anchor of the rear seat belt outer with the bolt.
| 4. INSTALL QUARTER TRIM LOWER PANEL LH |
![]() |
Engage the 2 claws and 2 clips, and install the quarter trim lower panel.
| 5. INSTALL LUGGAGE COMPARTMENT SIDE TRAY |
![]() |
w/ Woofer:
Engage the 5 claws and 7 clips, and install the luggage compartment side tray.
Tighten the bolt.
![]() |
w/o Woofer:
Engage the 5 claws and 5 clips, and install the luggage compartment side tray.
Tighten the 3 bolts.
| 6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Install the rear door opening trim weatherstrip.
| 7. INSTALL REAR DOOR SCUFF PLATE LH |
![]() |
Engage the 8 claws and install the rear door scuff plate.
| 8. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY LH |
![]() |
Install the rear seat back hinge with the 2 bolts.
| 9. INSTALL REAR SEAT BACK ASSEMBLY LH |
![]() |
Install the rear seat back with the 2 bolts.
| 10. INSTALL REAR SEAT BACK HINGE COVER |
![]() |
for LH Side:
Engage the 3 claws and install the rear seat back hinge cover.
for RH Side:
Remove the rear seat back hinge cover .
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT SRS WARNING LIGHT |